| Technical
Specifications |
| Metering |
3
digit DPMs for voltage and current measurement. |
| Meter Accuracy |
±3
counts. |
| Constant
Voltage Mode |
|
| Regulation |
Line : ±0.01%
±2mV for ±10% change in line voltage.
Load : ±0.01% ±2mV for load change from zero to full
load. |
| Ripple
and Noise |
1mV rms max.
20Hz to 20MHz. |
| Constant
Current Mode |
|
| Regulation |
Line : ±0.05%
±10mA for ±10% change in line voltage.
Load : ±0.05% ±10mA for change in output voltage from
0 volts to maximum output voltage. |
| Ripple
and Noise |
See Table. |
| Mode
Indication |
LED indication
for constant voltage / constant current operation mode. |
| Output
Polarity |
Floating w.r.t.
ground. |
| Overload
Protection |
Constant current
type. |
| Transient
Response |
100µsec
within 10mV of set output voltage for load change from 10% to 90%. |
| Stability |
Total drift
within 8 hours, after 30 minutes warm-up under constant line, load
and temperature.
< ±0.2% ±10mV in CV mode.
< ±0.5% ±10mA in current mode. |
| Operating
Temperature |
0
to 50ºC. |
| Temp.
Coefficient |
±0.05%
±5mV per ºC after initial warm-up of 30 minutes, in
voltage mode. |
| Line
Voltage |
230V AC ±10%,
single phase 50Hz. |
| NOTE
: REGULATION TO BE MEASURED AT SENSE TERMINALS. |
| CUSTOM
CAPABILITY : SPECIAL VOLTAGE AND CURRENT RATINGS AVAILABLE ON
REQUEST. |
